Skip to content
Open Data Finder
Opendatasoft hubLive preview

Untargeted metabolomic analyses on seeds of six Camelina sativa genotypes cultivated for five consecutive years

Published by Boutet, Stephanie

About this dataset

Lien vers la fiche source Samples collection: Six different genotypes of camelina were grown at the experimental farm of Bologna University (Italy) located in Cadriano (Bologna, Italy, 44°30′N, 11°23′E, 32 m a.s.l.) during five consecutive years (2015 - 2019). The six tested genotypes were: MIDAS (AAFC, Saskatoon, Canada), OMEGA (University of Poznan, Poland), WUR (Wageningen University and Research, The Netherlands), and 787-08, 789-02 and 887 cultivars (Smart Earth Camelina, Saskatoon, Canada). Camelina was sown each year in late winter/early spring accordingly to the specific meteorological conditions. The same agronomic management for all the trials was adopted consisting in typical tillage system (ploughing + harrowing), a seeding rate of 500 seeds m-2, no irrigation, a top-dressing fertilization with N (50 kg N ha-1, as urea at bolting stage), with no pest, disease nor weed chemical control. The experimental design was a randomized complete block with 3 or 4 replicates depending on the year. Representative seed samples from individual plots were cleaned and used for omic analyses. Extraction: Metabolites were extracted from 60 mg of camelina dry mature seeds. Briefly, 1 mL of MeOH: Methyl-tert-butyl: H2O (1:3:1), conserved at 4°C, and 200 ng of Apigenin (used as internal standard) were added to each sample, which were then homogenized in 2ml tubes using a FastPrep instrument (1 min, 14,000 rpm). The mixtures were then shaken for 30 min at 4ºC using a ThermoMixer™ C (Eppendorf), placed in an ice cooled ultrasonication bath for 15 min and centrifuged for 1 min at the maximum speed to remove debris. The extracted samples were then transferred in new tubes containing 650 mL of MeOH: water (1:3), previously placed at -20ºC. The mixtures were centrifuged for 1 min at 14,000 rpm. The addition of MeOH: water (1:3) and the centrifugation led to a led to a phase separation, providing the upper organic phase, containing the lipids, a lower aqueous phase, containing the polar and semi- polar metabolites, and a pellet of starch and proteins. The phase containing the polar and semi-polar metabolites was dried down in a SpeedVac vacuum concentrator (o/n) and resuspended in 200 μL of ULC/MS grade water (Biosolve). Chromatography: A Nucleoshell RP 18 plus reversed-phase column (2 x 100 mm, 2.7 μm; Macherey-Nagel) was used for chromatographic separation. The mobile phases used for the chromatographic separation were (A) 0.1% formic acid in H2O and (B) 0.1% formic acid in acetonitrile. The flow rate was of 400 μL/min and the following gradient was used: 95% of A for 1-min, followed by a linear gradient from 95% A to 80% A from 1 to 3-min, then a linear gradient from 80% A to 75% A from 3 to 8-min, a linear gradient from 75% A to 40% A from 8 to 20-min. 0% of A was hold until 24-min, followed by a linear gradient from 0% A to 95% A from 24 to 27-min. Finally, the column was washed by 30% A at for 3.5min then re-equilibrated for 3.5-min (35-min total run time). Mass spectrometry: Data-dependent acquisition (DDA) methods were used for mass spectrometer data in positive and negative ESI modes using the following parameters: capillary voltage, 4.5kV; nebuliser gas flow, 2.1 bar; dry gas flow, 6 L/min; drying gas in the heated electrospray source temperature, 140ºC. Samples were analysed at 8Hz with a mass range of 100 to 1500 m/z. Stepping acquisition parameters were created to improve the fragmentation profile with a collision RF from 200 to 700 Vpp, a transfer time from 20 to 70 µs and collision energy from 20 to 40 eV. Each cycle included a MS fullscan and 5 MS/MS CID on the 5 main ions of the previous MS spectrum. Data transformation: The .d data files (Bruker Daltonics, Bremen, Germany) were converted to .mzXML format using the MSConvert software (ProteoWizard package 3.0). mzXML data processing, mass detection, chromatogram building, deconvolution, samples alignment, and data export, were performed using MZmine 2.52 software (http://mzmin

Live preview

The first rows, fetched from Opendatasoft hub when you open this page.

Loading the first rows from the source…

Untargeted metabolomic analyses on seeds of six Camelina sativa genotypes cultivated fo… · Open Data Finder