EP 787 Rail Service Data
About this dataset
IMPORTANT NOTICE: " November 5, 2026: CSXT Service Outage Impacts on EP-787 and EP-724 Data Reporting for Week Ending October 30, 2026 CSX notified the Board that a system outage on October 27 disrupted several systems that provide data for the EP 724 and EP 787 metrics. As of October 30, all affected systems had been restored, and data accuracy had been verified. However, CSX is unable to recover the missing data. As a result, EP 724 and EP 787 reports will not include data for October 27-29. If the missing data is recovered, CSX has committed to filing restated reports for the week ending October 30, 2026." This dataset encompasses rail service reliability performance data collected under Docket No. EP 787. Each week, Class I railroads provide information on key service reliability metrics. The metrics Original Estimated Time of Arrival (OETA) and Industry Sport and Pull (ISP) are reported on a weekly average basis. Original estimated time of arrival OETA metric. The OETA metric is the percentage of shipments on a carrier’s system that moved in manifest service and were delivered to the designated destination no later than 24 hours after the OETA, out of all shipments on the carrier’s system that moved in manifest service during that week. For the purpose of calculating the OETA metric, once a carrier has communicated an OETA to a customer, that time shall not be changed by any subsequent changes to the original trip plan of the car, unless the change to the original trip plan is made in response to a shipper’s request or a shipper’s failure to make cars available for pick-up. OETA applicability. The OETA metric applies to shipments that travel as manifest traffic only within the United States. The OETA metric does not apply to cars placed in bad order status during shipment. Industry spot and pull (ISP) ISP metric. The ISP metric is the percentage of scheduled spots or pulls (i.e., those requested by a shipper or receiver before the applicable cut-off time) that were successfully performed during the planned service windows, out of the total number of spots or pulls that were scheduled for that week. A Class I rail carrier must report the ISP metric for each of its operating divisions and for the carrier’s overall system. For reporting at the operating division level, a Class I rail carrier may establish reporting regions using any geographic boundaries it chooses, provided that it identifies the boundaries in its methodology document submitted to the Board. Failure to spot a constructively placed railcar that has been ordered in by the cut-off time applicable to the customer for a planned service window shall be included as a failure in calculating the ISP metric. This includes “spot on arrival” railcars (i.e., railcars that may be placed without placement instructions) that have been constructively placed for any reason. Failure to spot a “spot on arrival” railcar for a planned service window shall be included as a failure in calculating the ISP metric if the railcar arrived at the local yard that services the customer and was ready for local service before the cut-off time applicable to the customer. If a Class I rail carrier cancels a service window, other than at the shipper’s or receiver’s request, each planned spot or pull from the cancelled service window shall be included as a failure in calculating the ISP metric. When a rail customer causes a Class I rail carrier to miss a spot or a pull during a planned service window, those spots or pulls will not be considered failures in calculating the ISP metric. ISP applicability. The ISP metric shall not include unit trains, intermodal traffic, or cars placed in bad order status after arrival at the serving yard. Methodologies The calculation and derivation of measures may vary by Class I railroad based on each carrier’s operational practices and reporting methodologies. While all Class I rail carriers submit data in accordance with Surface Transportation Board reporting
Live preview
The first rows, fetched from Opendatasoft hub when you open this page.
Loading the first rows from the source…