Effects of herbicide exposure on growth of the cyanobacteria Microcystis aeruginosa (Cyanophyta) (NESP TWQ 3.1.5, AIMS and JCU)
Published by Australian Ocean Data Network
About this dataset
This dataset shows the effects of imazapic (detected in the Great Barrier Reef catchments) on the growth rate (from cell density data) on the cyanobacteria Microcystis aeruginosa over a 72 hour exposure period during laboratory experiments conducted in 2019. The aims of this project were to develop and apply standard ecotoxicology protocols to determine the effects of Photosystem II (PSII) and alternative herbicides on the growth of the cyanobacteria Microcystis aeruginosa. Growth bioassays were performed over 3-day exposures using imazapic which has been detected in the Great Barrier Reef catchment area (O’Brien et al. 2016). This toxicity data will enable improved assessment of the risks posed by the herbicide imazapic to cyanobacteria for both regulatory purposes and for comparison with other taxa. Methods: The cyanobacteria Microcystis aeruginosa (Kutzing) Kutzing 1846 (Cyanophyceae) (CS338/01) was purchased from the Australian National Algae Supply Service, Hobart (CSIRO). Cultures of M. aeruginosa were established in MLA medium (Bolch and Blackburn 1996). Cultures were maintained in sterile 250 mL Erlenmeyer flasks as batch cultures in exponential growth phase with weekly transfers of 1 - 3 mL of a 7 day-old M. aeruginosa suspension to 100 mL MLA medium under sterile conditions. Clean culture solutions were maintained at 26 ± 2°C, and under a 12:12 h light:dark cycle (91 ± 12 µmol photons m–2 s–1). Imazapic stock solution was prepared using PESTANAL (Sigma-Aldrich) analytical grade (HPLC greater than or equal to 98%) imazapic (CAS 104098-48-8). The selection of imazapic was based on application rates and detection in coastal waters of the GBR (Grant et al. 2017, O’Brien et al. 2016). Imazapic stock solution was prepared in 1 L volumetric flasks using milli-Q water. Imazapic was dissolved using analytical grade methanol (final concentration < 0.01% (v/v) in exposures). Cultures of M. aeruginosa were exposed to a range of herbicide concentrations over a period of 72 h. The inoculum was taken from cultures in the exponential growth phase (4 - 7-day-old cultures). A M. aeruginosa working suspension was prepared in a 100 mL volumetric flask. A 1:10 and 1:100 dilution was prepared and counted using a haemocytometer under a compound microscope to determine appropriate dilution volumes. The pre-determined inoculum was added to 50 mL of each test and control treatment replicates to the required dilution (3.1 x 104 cells / mL). A control (no herbicide) and solvent control treatment was added to support the validity of the test protocols and to monitor continued performance of the assays. All treatment concentrations were prepared in 0.5x strength MLA medium. Replicates were incubated at 26.6 ± 0.5 °C under a 12:12 h light:dark cycle (59 ± 9.7 µmol photons m–2 s–1). Sub-samples were taken from each replicate to measure cell densities of algal populations at 72 h using a haemocytometer under phase contrast conditions. Cell counts were done manually. Specific growth rates (SGR) were expressed as the logarithmic increase in cell density from day i (ti) to day j (tj) as per equation (1), where SGRi-j is the specific growth rate from time i to j; Xj is the cell density at day j and Xi is the cell density at day i (OECD 2011). SGR i-j = [(ln Xj - ln Xi )/(tj - ti )] (day-1) (1) SGR relative to the solvent control treatment was used to derive chronic effect values for growth inhibition. A test was considered valid if the SGR of solvent control replicates was ? 0.92 day-1 (OECD 2011). Physical and chemical characteristics (pH, electrical conductivity and temperature) of each treatment solution was measured at 0 hr and 72 hr. Growth cabinet temperature was logged in 15-min intervals over the total test duration. Analytical samples were taken at 0 hr and 72 hr. Mean percent inhibition in SGR of each treatment relative to the control treatment was calculated as per equation (2)(OECD 2011), where Xcontrol is the average SGR of solvent control