Alluvial and Hillslope Gully Mapping – Digital gully mapping based on lidar data collected 2018-2019 in sections of the Burdekin, Fitzroy, and Normanby catchments. (NESP TWQ 5.10, Griffith University)
Published by Australian Ocean Data Network
About this dataset
This dataset contains maps of alluvial and hillslope gullies across four large blocks of lidar covering portions of the Burdekin, Fitzroy, and Normanby Catchments. The gully polygons were generated using methods developed in the NESP 5.10 project for the extraction of gullies from lidar. Lidar is detailed topographic data collected from aircraft using an airborne laser scanning system. A significant component of the cause of declining water quality and the health of the GBR is increased land based erosion leading to sediment pollution within the rivers draining into the GBR lagoon. Gullies are a significant proportion of the erosional sediment sources within the GBR catchments. Lidar is detailed topographic data collected from aircraft using an airborne laser scanning system. Airborne lidar data and orthophotography were acquired for the three study areas (portions of the Burdekin, Fitzroy, and Normanby Catchments) in 2018 and 2019 as part of a Department of Environment and Energy program to improve investment prioritisation in the management of erosion and fine sediment losses to the reef through the establishment of a new baseline of extent of gully and streambank erosion. CSIRO undertook and oversaw the program, contracting the aerial imaging and mapping company Aerometrex to acquire, process and provide the data. The data provider supplied classified lidar point cloud data, orthophotography imagery, and Digital Elevation Models (DEM), with 0.5 m cell size, derived from point cloud data. To produce DEMs the points within the cloud must be classified into ground and non-ground points. CSIRO performed quality control analyses of the provided point cloud data and the ground/non-ground classification. The lidar acquisition achieved average point densities in the range of 20 to 30 ground points per square metre. The DEMs supplied by the data provider, via CSIRO, were used for this mapping dataset. Griffith University developed methods and processes to map alluvial and hillslope gully polygons, estimates of potential active erosion within gullies, and estimates of total volume of sediment eroded over the lifetime of these gullies. The conceptual model of the gullies that are being mapped, stems from work undertaken through NESP Project 4.9, and prior to that the MTSRF Normanby Sediment Budget Project which followed on from projects undertaken through the TRaCK Program. Methods: The project that produced this dataset was an investigation into developing methods to extract gullies from digital topographic data and is almost entirely a processing method. A full description of the method is available in the NESP 5.10 report. Below is a summary of the method. The data provider (Aerometrex) supplied classified lidar point cloud data, orthophotography imagery, and Digital Elevation Models (DEM), with 0.5 m raster cell size, derived from point cloud data. The DEMs were hydrologically conditioned making the modelled hydrology derived from the DEMs continuous and without disruptions. A mask of channels, roads, and dams was produced and these areas of the DEM removed from the analysis. The landscape setting was analysed and separated into rugged areas and flat to gently undulating areas, that is, hillslope and alluvial landscapes. Landscapes, in certain configuration, exhibit a distinct break in slope that denotes a change of the predominant geomorphological processes acting on the landscape. A commonly observed break in slope in the landscape is the transition from hillslopes to alluvial floodplains. A break in slope can be observed where a mostly stable land surface changes to a predominantly eroding land surface. An example of this change is observed in large floodplains where the near horizontal surface of the floodplain is interrupted by a gully incising into the floodplain material. Another example is on hillslopes where the stable slopes are interrupted by a gully incising into the soil mantle. These breaks in slope (referred to as ‘