Effects of herbicide exposure on growth of the stonewort Ceratophyllum demersum (Tracheophyta – Magnoliopsida) (NESP TWQ 3.1.5, AIMS and JCU)
Published by Australian Ocean Data Network
About this dataset
This dataset shows the effects of herbicides (detected in the Great Barrier Reef catchments) on the growth rates (from stem length and biomass) on the stonewort Ceratophyllum demersum during laboratory experiments conducted in 2019. The aims of this project were to develop and apply standard ecotoxicology protocols to determine the effects of non-PSII herbicides on the growth of the stonewort Ceratophyllum demersum. Growth bioassays were performed over 7-day exposures using herbicides that have been detected in the Great Barrier Reef catchment area (O’Brien et al. 2016). This toxicity data will enable improved assessment of the risks posed by non-PSII herbicides to aquatic macrophytes for both regulatory purposes and for comparison with other taxa. Methods: The stonewort Ceratophyllum demersum was supplied by Watergarden Paradise Aquatic Nursery, Bass Hill, NSW. Cultures were maintained in 500 L outdoor plastic tanks in recirculating dechlorinated tap water, aerated and maintained at ambient outdoor temperature and lighting. Test replicates selected 48 h in advance and acclimated in dechlorinated tap water, 26 ± 2 °C, under a 12:12 hr light:dark cycle (102 ± 9 µmol photons m–2 s–1). Herbicide stock solutions were prepared using PESTANAL (Sigma-Aldrich) analytical grade products (HPLC less than or equal to 98%): haloxyfop-p-methyl (CAS 72619-32-0), imazapic (CAS 104098-48-8) and triclopyr (CAS 5535-06-3). The selection of herbicides was based on application rates and detection in coastal waters of the GBR (Grant et al. 2017, O’Brien et al. 2016). Stock solutions were prepared in 500 mL glass volumetric flasks using milli-Q water. Haloxyfop-p-methyl was dissolved using analytical grade acetone (< 0.01% (v/v) in exposures). Imazapic was dissolved in methanol (less than or equal to 0.01% (v/v) in exposure). No solvent carrier was used for the preparation of triclopyr. Cultures of Ceratophyllum demersum were exposed to a range of herbicide concentrations over a period of 7 days. Plants were sourced from actively growing cultures free of overt disease or deformity. Individual plants approximately 35 mm long with 5 whorls and an apical tip were added to 150 mL of each herbicide solution concentration and control treatment. In each toxicity test, a control (no herbicide) and solvent control (if used) treatments were added to support the validity of the test protocols and to monitor continued performance of the assays. Experiments were conducted in autoclaved, recirculating dechlorinated tap water. Five replicates of each treatment solution and control were prepared and incubated at 26.6 ± 0.5 °C under a 12:12 h light:dark cycle (90 ± 6 µmol photons m–2 s–1). Each replicate treatment was photographed at a standard height to measure stem length at Day 0 and Day 7. Biomass of a representative numbers of fronds were weighed at Day 0 to 3 significant figures using an analytical balance after blotting for 15 seconds to remove excess moisture. Fronds from each treatment replicate were weighed at Day 7 using the same technique. Specific growth rates (SGR) were expressed as the logarithmic increase in stem length (mm) or biomass (g) from day i (ti) to day j (tj) as per equation (1), where SGRi-j is the specific growth rate from time i to j; Xj is the stem length or biomass at day j and Xi is the stem length or biomass at day i (OECD 2006). SGRi-j =[(ln Xj - ln X i) / (tj - ti)] (day-1) (1) SGR relative to the control / solvent control treatment was used to derive chronic effect values for growth inhibition. A test was considered valid, if the SGR for frond number or surface area of control replicates was greater than or equal to 0.0495 day-1 determined from (OECD 2006 and Riethmuller et al 2003). Physical and chemical characteristics of each treatment were measured at 0 and 7 days including pH, electrical conductivity and temperature. Temperature was also logged in 15-min intervals over the total test duration. Analytical samples were taken at