Passive acoustic recordings from sonobuoys deployed during the NZ-Aus Antarctic Ecosystems Voyage 2015
Published by Australian Ocean Data Network
About this dataset
This dataset contains acoustic recordings from Directional Frequency Analysis and Recording (DIFAR) sonobuoys that were deployed throughout the 2015 NZ-Aus Antarctic Ecosystems Voyage. During the 42 day voyage 310 sonobuoys were deployed yielding 520 hours of acoustic recordings. Two models of sonobuoys were used during the voyage: 2 were AN/SSQ-53F (Ultra Electronics: SonobuoyTechSystems, USA) and 308 were re-lifed AN/SSQ-955-HIDAR (deployed in DIFAR compatibility mode; Ultra Electronics Sonar Systems, UK). A total team of four dedicated acousticians monitored round-the-clock for blue whales and in all weather conditions. After deployment, sonobuoys sent acoustic and directional data to the ship via a VHF radio transmitter. Radio signals from the sonobuoy were received using an omnidirectional VHF antenna (PCTel Inc. MFB1443; 3 dB gain tuned to 144 MHz centre frequency) and pre-amplifier (Minicircuits Inc. ZX60-33LN-S+) mounted on the mast of the ship at a height of 21 m. The preamplifier was connected to a power splitter via LMR400 cable and signals were received with two WiNRaDiO G39WSBe sonobuoy receivers. The radio signal from sonobuoys was adequate for monitoring and localization out to a typical range of 12-15 nmi. Received signals were digitised via the instrument inputs of a Fireface UFX sound board (RME Fireface; RME Inc.) with a gain set to 20 dB (8.396 V peak-peak voltage limits). Digitised signals were recorded on a personal computer as two-channel 48 kHz 24-bit WAV audio files using the software program PAMGuard (Gillespie et al. 2008). Directional calibration The magnetic compass in each sonobuoy was calibrated/validated upon deployment as described by Miller et al. (2015, 2016). Calibration procedure involved measuring the mean bearing error and standard deviation of errors between the GPS-derived bearing from the sonobuoy to the ship and the magnetic bearing to the ship noise detected by the sonobuoy. 15-20 bearings were used for each calibration as the ship steamed directly away from the deployment location. Intensity calibration Obtaining calibrated intensity measurements from sonobuoys not only requires knowledge of the sensitivity of the hydrophone, but also the calibration parameters of the radio transmitter and radio receiver. Throughout the voyage, a hydrophone sensitivity of -122 dB re 1 V/micro Pa was applied to recordings via the Hydrophone Array Manager in PAMGuard. This value is defined in the DIFAR specification as the reference intensity at 100 Hz that will generate a frequency deviation of 25 kHz (Maranda 2001), thus the specification combines the hydrophone sensitivity and transmitter calibration. In line with manufacturers specifications, the WiNRADiO G39 WSB had a measured voltage response of 1 V-peak–peak (approximately -3 dB) at 25 kHz frequency deviation (Miller et al. 2014), and this was subtracted from the hydrophone sensitivity to yield an total combined factor of 125 dB re 1 V/µPa. The gain of the instrument input on the Fireface UFX was set to 20 dB, yielding a maximum voltage input voltage range of 8.36 V peak–peak. These calibration settings, along with the shaped filter response provided by Greene et al. (2004) make it possible to obtain calibrated pressure amplitude from the recorded WAV audio files. Sonobuoy deployment metadata The PAMGuard DIFAR Module (Miller et al. 2016) was used to record the sonobuoy deployment metadata such as location, sonobuoy deployment number, and audio channel in the HydrophoneStreamers table of the PAMGuard database (PamguardBlueWhale-2015-02-03.mdb). A written sonobuoy deployment log (Sonobuoy deployment logbook - 2015 Tangaroa.pdf) was also kept during the voyage, and this includes additional notes and additional information not included in the PAMGuard Database such as sonobuoy type, and sonobuoy end-time. Real-time monitoring and analysis (Acoustic event log) Aural and visual monitoring of audio and spectrograms from each sonobuoy was conducted fo
Tags
- AMD
- AMD/AU
- CEOS
- CONTINENT > ANTARCTICA
- CONTINENT > ANTARCTICA > TERRA NOVA BAY
- CONTINENT > AUSTRALIA/NEW ZEALAND > NEW ZEALAND
- DIFAR
- EARTH SCIENCE > BIOLOGICAL CLASSIFICATION > ANIMALS/VERTEBRATES > MAMMALS > CETACEANS > BALEEN WHALE
- EARTH SCIENCE > BIOLOGICAL CLASSIFICATION > ANIMALS/VERTEBRATES > MAMMALS > CETACEANS > TOOTHED WHAL
- EARTH SCIENCE > OCEANS > OCEAN ACOUSTICS > AMBIENT NOISE
- GEOGRAPHIC REGION > POLAR
- GPS > Global Positioning System
- OCEAN > SOUTHERN OCEAN > Balleny Islands
- OCEAN > SOUTHERN OCEAN > ROSS SEA
- PASSIVE ACOUSTIC MONITORING
- R/V TANGAROA
- SONOBUOYS
- SORP