Skip to content
Open Data Finder
data.gov.au

U-Pb-Hf zircon data from Bruce Rise and Naturaliste Plateau

Published by Australian Ocean Data Network

About this dataset

These dataset files (2 tables) are supplementary material to: Halpin, J.A., Daczko, N.R., Direen, N.G., Mulder, J.A., Murphy, R.C., Ishihara, T., 2020. Provenance of rifted continental crust at the nexus of East Gondwana breakup. Lithos 354-355. https://www.sciencedirect.com/science/article/pii/S0024493719305237?via%3Dihub https://doi.org/10.1016/j.lithos.2019.105363 They include: Supplementary Table 1. Zircon U-Pb datasets Supplementary Table 2. Zircon Lu-Hf datasets Sample details from Halpin et al. (2020): Ishihara et al. (1996) made initial reports of the dredge sites from which our analyses have been made. Dredging at four sites on the eastern margin of the Bruce Rise was undertaken during cruise TH-94 of the R/V Hakurei-Maru during the austral summer of 1994/5, along with other geophysical data acquisition reported in Ishihara et al. (1996). Of the four sites dredged, sites D1502, D1503 and D1504 all recorded hauls of basement rocks, including crystalline basement fragments. These dredge sites and hauls are summarised in Table 1. The recovered dredge samples have variable shapes, but the samples analysed here (two granites from D1502; Fig. 3) contain sharp and unweathered faces consistent with dredging from in situ basement. The interpretation of composite seismic profiles TH94/21 and GA-229/19 from the eastern flank of the Bruce Rise (Fig. 1b) shows a folded and faulted syn-rift sequence that thickens towards the south and is separated from flat-lying post-rift sediments by a prominent erosional unconformity (Stagg et al., 2006). The outermost ridge, flanked by the Vincennes Fracture Zone, is interpreted to comprise exposed crystalline basement, and we interpret the granitic samples studied here to represent parts of this basement complex. Sample D1502-A is a medium to coarse-grained (~2–4 mm) red granite, whereas sample D1502-B is a fine to medium-grained (~1–1.5 mm) cream-grey granite (Fig. 3a). Both samples comprise quartz, plagioclase, alkali feldspars (including microcline), biotite and accessory magnetite and zircon. Sample D1502-B additionally contains minor biotite-amphibole-rich schlieren. Biotite is variably orientated suggesting weak magmatic foliation. The low-strain character of the samples is supported by very limited undulose extinction of some grains, minor development of sub grains in quartz, and preserved igneous microstructures that include subhedral feldspar grains presenting some crystal faces (red lines, Fig. 3b), quartz-feldspar interstitial textures (blue ‘i’, Fig. 3b), low dihedral angles (double blue arrow heads, Fig. 3b), elongate mineral films along grain boundaries that are inferred to have pseudomorphed former melt, and growth twinning in plagioclase. Minor low-temperature alteration of feldspar and biotite to sericite ± chlorite is observed in sample D1502-A. High resolution whole thin section photomicrographs are available at https:// imagematrix.science.mq.edu.au/. Details of analytical methods from Halpin et al. (2020): Initial sample preparation including zircon separation and mounting was performed at Curtin University. Zircon grains were imaged via cathodoluminescence (CL) on a FEI Quanta 600 SEM at the Central Science Laboratory, University of Tasmania, to reveal internal structure in order to optimise and contextualise U-Pb analyses. U-Pb zircon analyses were performed on an Agilent 7500cs quadrupole ICPMS with a 193nm Coherent Ar-F gas laser and the Resonetics S155 ablation cell at the Discipline of Earth Sciences, University of Tasmania. Each analysis was pre-ablated with 5 laser pulses to remove the surface contamination then the blank gas was analysed for 30 s followed by 30 s of zircon ablation at 5 Hz and ~2 J/cm2 using a spot size of 29 μm. Isotopes measured include 49Ti, 56Fe, 91Zr, 178Hf, 202Hg, 204Pb, 206Pb, 207Pb, 208Pb, 232Th and 238U. The down hole fractionation, instrument drift and mass bias correction factors for Pb/U and Pb/Th ratios on zircons were calculated usin

U-Pb-Hf zircon data from Bruce Rise and Naturaliste Plateau · Open Data Finder