Effects of herbicide exposure on growth and photosynthetic efficiency of the lesser duckweed Lemna aequinoctialis (Tracheophyta – Liliopsida) (NESP TWQ 3.1.5, AIMS and JCU)
Published by Australian Ocean Data Network
About this dataset
This dataset shows the effects of herbicides (detected in the Great Barrier Reef catchments) on the growth rates (from frond number and surface area) and photosynthesis (effective quantum yield) on the duckweed Lemna aequinoctialis during laboratory experiments conducted from 2017-2019. The aims of this project were to develop and apply standard ecotoxicology protocols to determine the effects of Photosystem II (PSII) and alternative herbicides on the growth and photosynthetic efficiency of the lesser duckweed Lemna aequinoctialis. Growth bioassays were performed over 4-day exposures using herbicides that have been detected in the Great Barrier Reef catchment area (O’Brien et al. 2016). Chronic effects of herbicides on the photophysiology of L. aequinoctialis, measured by chlorophyll fluorescence as the effective quantum yield (Delta F/Fm') were investigated using mini-PAM fluorometry after 4-day herbicide exposure. These toxicity data will enable improved assessment of the risks posed by PSII and alternative herbicides to aquatic macrophytes for both regulatory purposes and for comparison with other taxa. Methods: The lesser duckweed Lemna aequinoctialis was supplied by the Supervising Scientist, Department Agriculture, Water & Environment, Darwin, N.T.). Cultures were established in 0.5x strength CAAC medium (Riethmuller et al 2003; Pease et al 2016). Cultures were maintained in sterile 250 mL Erlenmeyer flasks as batch cultures with weekly transfers of 5-10 triplicate fronds to 100 mL 0.5x strength CAAC medium under sterile conditions. Clean culture solutions were maintained at 26 ± 2°C under a 12:12 h light:dark cycle (41 ± 5 µmol photons m–2 s–1). Herbicide stock solutions were prepared using PESTANAL (Sigma-Aldrich) analytical grade products (HPLC greater than or equal to 98%): bromacil (CAS 314-40-9); diuron (CAS 330-54-1), fluroxypyr (CAS 69377-81-7), haloxyfop-p-methyl (CAS 72619-32-0), hexazinone (CAS 51235-04-2), imazapic (CAS 104098-48-8), isoxaflutole (CAS 141112-29-0), prometryn (CAS 7287-19-6), propazine (CAS 139-40-2) and triclopyr (CAS 5535-06-3). The selection of herbicides was based on application rates and detection in coastal waters of the GBR (Grant et al. 2017, O’Brien et al. 2016). Stock solutions were prepared in 1 L glass volumetric flasks using milli-Q water. Diuron, haloxyfop-p-methyl, hexazinone, isoxaflutole and prometryn were dissolved using analytical grade acetone (< 0.01% (v/v) in exposures). Imazapic was dissolved in methanol (less than or equal to 0.01% (v/v) in exposure). No solvent carrier was used for the preparation of the remaining herbicide stock solutions. Cultures of L. aequinoctialis were exposed to a range of herbicide concentrations over a period of 96 h. Inoculum was taken from actively growing cultures free of overt disease or deformity. Four triplicate fronds were added to 100 mL of each herbicide solution concentration and control treatment. In each toxicity test, a control (no herbicide) and solvent control (if used) treatments were added to support the validity of the test protocols and to monitor continued performance of the assays. Experiments were conducted in either 0.25 CAAC with no added sucrose (Riethmuller et al 2003) or synthetic soft water (SSW) (Pease et al 2016). Three replicates of each treatment solution and control were prepared and incubated at 26.6 ± 0.5 °C under a 12:12 h light:dark cycle (110 ± 13 µmol photons m–2 s–1). Each replicate treatment was photographed at a standard height (Riethmuller et al 2003; Pease et al 2016) to estimate surface area and frond number at Day 0 and Day 4. Specific growth rates (SGR) were expressed as the logarithmic increase in surface area or frond number from day i (ti) to day j (tj) as per equation (1), where SGRi-j is the specific growth rate from time i to j; Xj is the surface area or frond number at day j and Xi is the surface area or frond number at day i (OECD 2006). SGR i-j = [(ln Xj - ln Xi )/(tj - ti )] (day-1) (1)