Coral recruitment patterns within and among reefs in the Cairns-Port Douglas region from 2023/2024-2024/2025 (RTP, Reef Hub, JCU TropWATER)
Published by Australian Ocean Data Network
About this dataset
This dataset consists of two years of relative coral recruitment from within and among reefs in the Cairns-Port Douglas region from 2023 to 2025. The dataset includes one csv of the site gps coordinates where recruitment tiles were deployed during annual mass spawning periods in 2023/2024 and 2024/2025. A second csv file provides a summary of recruits recorded per tile at each site in total and, where possible, total recruits for three Scleractinia family groups or ‘Other’ where not identifiable. Recruit data is also recorded as the total number of recruits per side of each tile (‘top’, ‘bottom’, and ‘sides’). The third csv provides Rapid Health Impact Survey data collected at the same sites and time where and when tiles were deployed. A fourth csv provides the temperature recorded in situ at sites where recruitment tiles were deployed over a continuous two-year period where possible with some data omissions due to logger failure or loss. Methods: Settlement tiles were deployed at 5 reefs (Opal Reef, Agincourt Reef, Hastings Reef, Moore Reef, Flynn Reef) across 15 sites over two years to quantify relative coral recruitment following mass spawning periods (November – January each year). In year 2 (2024/2025), a sixth reef, Rudder Reef, was added to the study with three additional sites. Sites were located at a similar depth stratum (6-8 m below mean sea level) in a similar reef zonation in the back reef lagoon. At each site, 15 recruitment tiles were deployed. Tiles were constructed from locally quarried limestone and cut to standard dimensions (9 × 9 × 1 cm). A single hole was drilled through the centre of each tile in order to be mounted on 8 mm stainless steel rods (~20 cm length), which were inserted 5–10 cm into reef substrate. Tiles were spaced ~5 m apart within a maximum spatial extent of 100 m per site. Two cable ties were secured at the base of rods for the tiles to rest on in order to create a ~1.5cm space between the reef substrate and tile. Prior to deployment, a light ‘X’ groove had been etched using a small rotary drill to the underside of each tile in order to differentiate the top orientation from the bottom orientation when retrieved from deployment periods. A rubber washer was placed at the top of each metal rod after the tile was added to ensure tiles could not be dislodged from rods during deployment periods. Tiles were deployed each year approximately six weeks prior to expected mass spawning events which were predicted to be 3-5 nights following the November full moon. This period allowed natural biofilm and benthic community development to condition tile surfaces. Temperature loggers were also secured in place at each reef site adjacent to deployed tiles and left in place over the entirety of the two year study apart from logger change outs at six month intervals to mitigate data or logger losses. Rapid Health Impact Surveys (Beeden et al. 2014) were carried out at the time of tile deployment or within a few weeks of deployment. GPS locations were recorded at all study sites. Tiles were left in place four to six weeks following the subsequent January full moon to capture the variety of species that may spawn across these known peak spawning months on the Great Barrier Reef equating to 90-105 days for tile deployments in total. Retrieved tiles were threaded onto metal rods separated by 2 cm rubber spacers to prevent contact and damage during transport. A small number (1-2) tiles were lost at some sites especially following TC Jasper impacts in year 1. Tiles on rods were carefully mounted in milk crates or similar containers to avoid tile damage. Retrieved tiles were left on metal rods but placed in large nally tubs where they were fully submerged in a 24 hour, 10% bleach solution to remove all living material. Tiles were gently rinsed and allowed to air dry before being returned to the lab for further analysis. In the lab, tiles were assessed on all surfaces for hard coral recruits using stereo microscopes